Depends strongly on the type of product, battery, material and applications.

The charger stops automatically when the battery is fully charged.

Under normal conditions approximately 1 hour

To have a back up option for continuous working.

Use right accessories for the right tools and applications. Keep all the contacts free of dust and oil substances. Run the tool without load for 1 minute after usage to take out the dust inside.

Exact specification of the number of meters is not possible. (Many different influencing variables - Material properties, machine, power, disc selection, disc diameter, cutting depth, handling, user andmany others.

Yes, a dry disc can also be used for wet applications. (Dry disc can withstand high temperatures - Hardly any heat is created during wet applications )

No, a wet disc should never be used for dry applications. (Wet disc is not designed for high temperatures - A lot of heat is created during dry applications)

No. Diamond cutting discs are only certified for cutting . Not designed for high lateral forces.

Avoid heat. (Heat is created with - Dry applications , Wet applications with insufficient water , High cutting requirements , Very hard materials )

Apply cooling intervals (Allow diamond cutting disc to cool down , With machine running and without material contact )

Maintain machine speed ( High speed means high material removal rate . Control by means of feed pressure , dependent on machine performance , material type , material thickness)

This is the accuracy, which can be realized on a distance of 10m under typical, meaning favorable, conditions (reflective target, no adverse light conditions, normal temperature & humidity)

Fast movement. Reduce the movement speed of the detector and try again at the same place.

Static electricity can lead to inaccurate indication of electric lines. To improve the indication , place your free hand flat on the wall next to the measuring tool in order to remove the static electricity.

It is possible that the wall shields the 50/60 Hz signal, if the cable is lying directly under the screed . It may also happen that the cable lies deeper than the detector maximum range.

The number lines/references it generate and the range it can reach.